Heavy Duty Wire Mesh
Heavy Duty Wire Mesh is stacked up from basic heights reinforced with flats, angles, tees, tubes, etc. Construction: Vertical posts must be used between panels for increased rigidity.
This special reinforcement when installed between panels gives maximum strength for great heights. This reinforcement is also recommended for lower height partition where extra strength is required. |
|
Mesh: |
- 6ga. (.192) steel wire triple crimped and woven into a 2" diamond mesh.
- 8ga. (1.62) Steel wire triple crimped woven into a 2" diamond mesh.
|
Vertical Frame: |
1 1/2" x 3/4" x 1/8" steel channel |
Horizontal Frame: |
1 1/2" x 3/4" x 1/8" steel channel |
Horizontal Stiffeners: |
Two 1" x 1/2" x 1/8" channels |
Panel frames mortised and tenoned at corners. |
Hinged Door Frames: (4 sides) |
1 1/2" x 3/4" x 1/8" steel channel with 1 1/2" x 1/8" flat bar capping |
Sliding Gate Frames: (4 sides) |
1 1/2" x 3/4" x 1/8" steel channel with 1 1/2" x 1/8" flat bar capping |
Locks: |
Mortise type cylinder lock with recessed turn knob inside and mortise cylinder outside. OPTIONAL: Handicap handle on inside. |
Corner Posts: |
1 1/2" x 1 1/2" x 1/8" steel angle or 1 1/2" x 1 1/2" x 1/8" square tube |
Top Capping: |
3" x 1" steel channel with 3/8" diameter bolt and nut min. 28" o.c. |
Fasteners: |
3/8" diameter bolt and nut vertically min. 12" o.c. |
|
Partition Height |
Material |
up to 16' 16' to 24' over 24' |
5/16" x 2 1/2" flat 5/16" x 3" flat 3" channel with welded base plate | |
Finish Options: |
Prime Painted Hot-Dip Galvanized One Finish Coat Enamel Polyester - Powder Coated |
Packaging: |
When material is shipped, paint finish may be marred. Field touch-up is normally required. Touch-up paint shall be provided. When special finishes are required, special packaging may be necessary. |
Technical Specifications
Installation: Wire partitions are designed that they may be erected by inexperienced labor. Shop Drawings are sent with all jobs so that your erector will understand how parts are assembled. Field bracing of partitions may be required, depending on the individual project and customer preferences. Bracing materials will be furnished only when the type and quantity are specified and requested. (Bracing is usually provided by the erector). All bolts and nuts that are required for assembly are provided. However, bolts, screws, floor and wall anchors required for attachment to building structure are not included, unless specified and requested.
Ordering: When ordering it is best to send a rough sketch, so that we may fabricate with the correct locations of doors and or sliding gates. Indicate the hinge side, swing direction and key side of all doors and sliding gates. Be sure to state the height and type of floor and wall conditions to which the partition are anchored. If there are pipes, ducts, beams, or other structural obstructions around which the partition must fit, please dimension these locations and their elevations (AFF - above finished floor).
|